Main
Tri-Fold Soft Tonneau Cover x1 For Nissan Navara D40 2005 - 2016 Double Cab - Damaged / Seconds
- Sale is for 1pc Tonneau Cover.
- Fits the Double Cab only.
- Easy installation - less that half an hour.
- Folds up and down - Simple & hassle free.
- This cover is easily fitted with alloy clamps supplied, no drilling needed.
** Description below is from original listing. Please note: Sale is for 1pc Tonneau Cover. These will need to be cleaned and may be fixing clamps components missing but this can be addressed by the buyer by using DIY skills. **
High-quality Tri-Fold Soft Tonneau Cover to suit Nissan Navara D40 Double Cab (2005 - 2016 Model). Your 4x4 will stand out from the crowd with this stylish and durable tonneau cover that is made to last.
Please Note: This cover can be fitted with certain Bragan roll bars. Please check our shop for relevant Roll Bar listings. Please ensure that your model is D40 Pre 2016 as opposed to the NP300 2016 + model.
This tonneau cover will give a greatly enhanced look to your vehicle but at a fraction of the cost of genuine items. Made to be tough, with reinforced black vinyl on a hardened aluminum side frame and centre cross bar supports, this Tri-Fold tonneau cover is both a practical and easy way to make your 4x4 stand out.
This cover is easily fitted with quick release alloy clamps supplied, no drilling needed. If you have an over rail bed liner 4 holes need to be drilled into the bed liner (easy to do) for clamps to affix. Most bed liners are under the rail and these covers will fit straight on. This soft tonneau cover clamps to bed side rails to give a neat and flush finish.
Please check the dimensions of your 4x4 bed with the dimensions of our cover below to ensure it will fit.
Dimensions: Length: 1530mm, Width: 1610mm Outside to Outside.
- Less fuel consumption due to wind resistance.
- Easy installation - less than half an hour.
- Folds up and down - Simple & hassle-free.
- Fits the Double Cab Only
- Email & phone technical support.
- This will not fit vehicle with factory fitted ladder rack.
Support bars are integrated into the cover to prevent water from gathering and to give a smooth taut finish. The rear part of cover is attached to side rails, and can only be opened when trucks locking tailgate is opened. This leaves that the cover can only be easily opened when the tailgate is opened by the vehicle key holder.
VAT Invoice, Fitting Instructions, and Tracking info will be sent as an email attachment after purchase - please check spam folder if not received.
Trade inquiries welcome.
* The product listed is not manufactured by the Original Equipment Manufacturer (“OEM”), unless specifically stated and where reference is made to the brand names of the OEMs, the references are for specification reference only and are not an endorsement by the OEM referred to. All warranties under consumer laws within the European Community Consumer Laws against defects are provided by the Seller.
